Mess-free UV DTF Pen Wrap Application Tutorial

Our UV DTF is sized as 4.4" x 1.24" and is designed to fit standard-sized pens. You are more than welcome to purchase our pen wrap and apply them to your own pens by cutting the wraps. However, please note that we do not offer refunds or replacements for any issues arising from the use of these decals on surfaces other than our specified blanks.

Watch This QUICK Video Tutorial: 

(If the video quality is low, please change the quality to 720p from 240p by clicking the cogwheel icon > Quality). 

Instructions:

1. Prepare Your Workspace:
   
   Ensure the pen and the UV DTF wrap are clean and dry. Choose a well-lit, dust-free area for the application.

2. Trim Pen Wrap on Both Sides:

   Make sure to cut the excess part of the pen wrap and cut very closely to the design on both sides. This is required to avoid adhesive being overlapped at the seam, which may cause application errors.

3. Peel Off Backing:

   Peel the backing completely, then place the pen on a straight surface with something to hold.
   
   In the video tutorial, I used my finger to secure the placement, but I'd recommend placing it on the table.
   
   Insert the pen wrap underneath the pen hook, then use your thumb to press down the pen wrap to secure the placement.
   
   Once secured, flip the pen and slowly start pressing the wrap around the pen. When you get to the other side of the pen, take scissors to cut a little slit so you can let down the wrap that will be applied below the pen hook.
   
   Then, for the remaining decal, you can either use your nail to push it in or use scissors to cut the excess, whichever you prefer to complete the application. Take time to push it with your finger to activate the adhesive.

4. Smooth Out Air Bubbles:
   
   As you wrap, use your fingers to smooth out any air bubbles or wrinkles. This step is crucial for a clean and professional finish.

5. Peel Off Carrier Sheet:

   SLOWLY, very slowly peel off the backing paper from the decal, ensuring it doesn't stretch or tear. I love using a sewing needle or needle pen for lifting the edge of the carrier sheet. If any part of the design lifts up as you peel, go back, gently push down on that area, and then resume peeling.

6. Activate Adhesive:
   
   It is recommended to let the applied project sit for 24 hours without use to allow the adhesive to activate completely. This ensures a strong and durable bond.

7. Enjoy Your Customized Pen:
   
   Once the adhesive has fully activated, your UV DTF-wrapped pen with a holder hook is ready to use! Show off your personalized creation and enjoy the festive touch it adds to your writing experience.

Remember, crafting should be fun, so take your time and enjoy the creative process! 🌟✨

**Please note we are not responsible for UV DTF transfers that are applied incorrectly or damaged during application. No refund or exchange will be offered.